Without Codes: Press the TV button → Press and hold the SETUP button → Enter 9-1-1 → Press the POWER and TV buttons → If the TV is turned off, the remote code is identified → Press the SETUP button to save the code.
With Codes: Press and hold the SET and POWER buttons → Release both buttons if the LED stays idle → Enter the code → If the code is valid, the LED light will go off → Else, try again with a new code.
WOW Remote can control TVs, home theatres, cable/set-top boxes, and audio devices. It has backlit buttons which help to use it even in low light. Being a universal remote control, you cannot use the WOW remote readily. Hence, you need to program the WOW remote with or without remote codes. Here you can find easy instructions to program your WOW remote to any device.
How to Program WOW Universal Remote Without Codes
You can also program the WOW remote to Samsung TV, cable box, or any device without a code.
1. Switch on your TV and press the TV button on the WOW remote once.
2. If the LED light blinks once, press the SETUP button and hold it until the TV button LED blinks twice.
3. After that, enter the buttons 9-1-1 in sequence. The TV button light will flash twice.
4. Following that, aim the remote at the TV sensor and press the POWER and TV buttons simultaneously.
5. If the TV gets turnedoff, it indicates that the WOW remote is searching for a code. In this case, it will automatically send remote codes to the TV and it will identify the correct code.
6. Press the SETUP button on the remote to store the code. The TV button light will flash twice to confirm.
That’s it. You have successfully programmed your WOW universal remote using the auto-search method. Press the channel, volume, or other keys on the remote to check if all the commands are properly responding to your device.
How to Program WOW Universal Remote With Codes
1. Switch on your TV by pressing the physical power button.
2. Take note of the remote code of your device from the table.
3. Press and keep hold of the SET and POWER buttons at a time.
4. The LED light will stay idle to indicate the remote is ready for programming.
5. Now, release the SET and POWER buttons.
6. Enter the device code which you can find in the below table.
7. If the code is valid, the LED light will turn off automatically.
8. In case the LED light flashes twice, the code is invalid. So, you have to try with a different code.
Important Note: You must enter the code within 10 seconds. Else, the program mode will be disabled.
9. After entering the right code, aim the remote at the TV receiver and press the POWER button.
10. If your TV gets turned off, you have successfully programmed the remote.
Note: If it fails, you can repeat the same steps with a new code.
Remove the batteries from the battery compartment. Press all the buttons repeatedly 3-4 times. Now, insert the batteries back into the remote. Grab the WOW remote and press the SETUP button and keep hold of it.
How to program the WOW remote to the cable box?
Turn on your WOW cable box and press the CBL button on the remote. Press and hold the SETUP key until the CBL button LED blinks twice. After that, enter the remote code and press the Power button. If it turns off the cable box, the remote programming is successful. Else, repeat the steps with a different code.
Hi! I am a content writer who loves writing simplified articles on technology. My father used to misplace his remotes all the time, and the search for the missing remote always ended up with her missing her favorite show. That’s when a friend introduced me to the remote apps, and I sort of got obsessed with the whole idea. I wanted to share all my research and knowledge on various remotes and remote apps in a space, and that’s where my blog (smarttvremoteapp.com) comes in. My articles on different kinds of remotes, alternative remote options, installing remote apps, various tricks, techniques, and troubleshooting fixes will be a friendly guide. I hope you find them helpful and easy to follow. Enjoy your TV experience!
